Technical Data Sheet ## Water-based paint for internal and external walls of natural gas pipelines in oil storage tanks Water-based Pipeline Coating · Category: Pipeline Specialized water-based coating for pipelines, providing long-term corrosion protection in buried, submerged, or atmospheric service. Compatible with cathodic protection systems. ## Key Features Long-term corrosion protection (10+ years) Resistant to soil stress and chemicals Compatible with cathodic protection Water-based, environmentally friendly Smooth surface, low friction loss ## Typical Applications Oil pipelinesGas pipelinesWater pipelinesDistrict heatingMarine pipelines ## Technical Specifications TypeWater-based epoxy / polyurethaneColorCustomSolid content≥ 65%DFT200-1000μm (single or multi-coat)Adhesion≥ 10 MPa (pull-off)Cathodic disbondment≤ 8mm @ 28 daysSalt spray≥ 1000hVOC< 80 g/LCoverage2-5 m²/kg @ 200μm DFT ## Application Notes Surface preparation: Remove all oil, grease, dirt, and loose rust. Abrasive blast to Sa 2½ (ISO 8501-1) for best results, or power tool clean to St 3 minimum. Apply on dry surface with substrate temperature at least 3°C above dew point. Mixing: Stir component A thoroughly, then add component B (if applicable) in the correct ratio. Mix with mechanical stirrer for 3 minutes until uniform. Pot life varies by product, typically 2 hours at 25°C. Application: Airless spray is recommended for best results. Brush or roller suitable for small areas and touch-up.